Features and specifications of our mass production of pipes for contact probe pins

ISO9001・ISO14001

TEL:0265-86-3175 | FAX:0265-86-4221

739 Iijima, Iijima-machi, Kamiina-gun, Nagano Prefecture

Contact us by email
  • 中文
  • 日本語
  • Company profile

Barrel for "Contact probe"

Production of between 100 and 500,000 pipes is possible.

Nanshin is very good at manufacturing very high-precision fine pipes, and receives an especially high amount of orders from customers both in Japan and overseas for pipes for contact probe pins used with semiconductor devices.
Let Nanshin deal with all your needs for even thinner, high-precision pipes for contact probe pins.

[Specifications of pipes for contact probe pins]

Material Ni-Au /Au-Ni-Au
Outer diameter Dimensions 0.04~1.00mm Dimensional precision ±0.003 standard
Inner diameter Dimensions 0.03~0.99mm Dimensional precision ±0.003 standard
Total length 1~10mm
Wall thickness(Sheet thickness) 0.01mm~
Hardness HV.350~500
Pipe internal roughness Ra. 0.1以下
Lot quantity 100 unit to 500,000 units

※Click the image to see a larger version.

Production of between 100 and 500,000 pipes is possible. Production of between 100 and 500,000 pipes is possible. Production of between 100 and 500,000 pipes is possible.

Please contact us for advice or estimates.

Features of Nanshin's pipes for contact probe pins

1: The wall thickness is about 50% that of conventional products.

Due to this, it is possible to select a larger size for the part to go inside without changing the external dimensions.
Using a larger part means improved part durability as well as contributing to reduced costs.
Nanshin's pipes bring excellent benefits for both performance improvement and cost reduction.

2: We have reduced the diameter and achieved even higher precision.

The semiconductor industry has been trying to achieve even smaller, high-density electric circuits. Part manufacturers must always be ahead of that trend and be ready to satisfy end users.
Nanshin already has small diameters and high precision for the next generation with a smallest pipe diameter is 0.04 mm with a standard tolerance of ±0.003 mm.

3: The internal gold plating can be freely controlled.

One attraction of Nanshin's pipes is the ability to control the internal gold plating which was not possible with conventional products.
We promise to flexibly meet your needs with a range of thicknesses from our thin-film plating (approximately 0.0005 mm) for cost performance to our thick-film plating (0.002 mm or more) for the strength to handle high frequencies.

Features of Nanshin's pipes for contact probe pins

Features of Nanshin's pipes for contact probe pins

Please contact us for advice or estimates.

Why we are so good at mass production

1: Many achievements over the years of pursuing high-precision fine pipe manufacturing

Nanshin has achieved mass production of very high-precision fine pipes with a level of precision not possible using machine tools and other methods. We are specialists at manufacturing pipes that exceed the limits of processing with adjustable hardness, internal roughness of Ra 0.1 or less, an even plating on the inside of more than 2 μm, and wall thicknesses adjustable from 0.01 mm to more than 3 mm, etc. This is the fruit of the technology we have accumulated over the years.

?Very high-precision fine pipes page

?Introduction of technology page

Why we are so good at mass production

2: We supply our customers with manufacturing they can trust with integrated production.

In order to achieve the very high-precision fine pipes to meet our customers' needs, we developed our own electroforming plant. Also, as we perform material procurement, production, inspection and shipment in-house as an integrated system, we are able to deliver products to our customers that they can trust.

2: We supply our customers with manufacturing they can trust with integrated production.

Please contact us for advice or estimates.

PAGE TOP